Specification

The Proscan 2D surface profilometer is a fast, accurate, non-contact 2D profilometer, used in a broad range of applications. Essential where the analysis of a surface is critical to the peformance, productivity or yield of the product. Combining the very latest in non-contact displacement sensors with sophisticated easy to use software.

Select the sensor for your application:

Sensor Model Measuring range Stand off Resolution Spot size Linearity
(% +/- of range) 		Technology
S5/03 300µm 5.0mm 0.01µm 4µm 0.1 Chromatic
S38/3 3mm 38.0mm 0.1µm 10µm 0.1 Chromatic
S65/10 10mm 65mm 0.3µm 50µm 0.1 Chromatic
L25/2H L25/2 2mm 25mm 0.1 0.2 30µm 65µm 0.05 0.1 TriangulationCCD
L35/10H L35/10 10mm 35mm 0.5 1 50µm 70µm 0.03 0.1 TriangulationCCD
L50/20H L50/20 20mm 50mm 1 2 45µm 45µm 0.03 0.1 TriangulationCCD
L70/50H L70/50 50mm 70mm 2.5 5 55µm 55µm 0.03 0.1 TriangulationCCD

 

Technical Specification

Scanner overall dimensions (w x h x d) 1130x 600 x 450mm
Electronic cabinet overall dimensions 315x 705 x 600mm
PC Monitor LCD Flatscreen
Granite table size 1130x 600 x 70mm
X travel 600mm
Electrical requirements 100- 110/220 - 240 VAC, 50/60Hz
Operating temperature 10- 35 deg C
Step size (minimum) 1µ
Step size (maximum) 9.99mm
Data collection rate (maximum)
depends on sensor & set up 		20,000points/sec
Scanning speed (maximum)
depends on set up 		90mm/sec
Retrace speed 100mm/sec
Maximum no. of data points 2400 (option available to increase to 20,000)
Features/Benefits

  1. Rugged construction means the Proscan 2D can be used on the shop floor or laboratory
  2. Large 600 mm scan
  3. High speed of measurement. A complete scan takes just a few seconds
  4. Very easy to use. Dedicated measuring software means that no special operator training is required yet provides a host of advanced analytical features
  5. Interchangeable non-contact sensors
  6. Full turnkey solution

 

This off-line profilometer will scan the top surface of objects over a distance of 600 mm. A graphical 2D representation of the scanned data will be shown on screen and by using the surface analysis tools the sample can be properly quantified.
A number of different sensors can be used with the Proscan 2D. This enables the end user flexibility to measure a wide variety of different materials with contrasting surface properties. Sensors with very small measuring ranges often used on very smooth surfaces to determine true surface roughness. Sensors with larger measuring ranges are used more on surfaces where profile has been produced and needs to be measured.

Applications

  1. Waviness on Gypsum board
  2. Flatness on sheet or board materials
  3. Surface profile of etched materials
Sorry there is no information for the Options section.